HL-L8260CDN

FAQs & Troubleshooting

FAQs & Troubleshooting

Replace Drum

The Brother machine has separate consumables the toner cartridge and the drum unit. Verify you replace only the drum unit and not the toner cartridge. If you want to know their difference, refer to "What is the difference between the toner cartridge and the drum unit?"

 

Replace the drum following the steps below:

 

Replacing the drum unit

  1. Make sure the machine is turned on.
  2. Press the front cover release button and pull open the front cover.
    Open Front Cover
  3. Hold the drum unit's green handle. Pull the drum unit out of the machine until it stops.
    Pull Drum Out
  4. Turn the green lock lever (1) counterclockwise until it locks in the release position. Holding the green handles of the drum unit, lift the front of the drum unit and remove it from the machine.
    Turn Green Lock Lever

    Hold the green handles of the drum unit when you carry it. DO NOT hold the sides of the drum unit.

    DO Not Hold Sides

  5. Unpack the new drum unit.
  6. Remove the protective cover.
    Remove Protective Cover
  7. Hold the handle of the toner cartridge and gently push it away from you to unlock it. Pull it up and out of the drum unit. Repeat this for all toner cartridges.
    Pull Toner Out
  8. Reinsert the toner cartridge into the new drum unit and gently pull it toward you until you hear it lock into place. Make sure that you match the toner cartridge color to the same color label on the drum unit. Repeat this for all toner cartridges.
    Insert Toner

    Make sure you put the toner cartridge in correctly or it may separate from the drum unit.

  9. Make sure the green lock lever (1) is in the release position, as shown in the illustration.
    Release Position
  10. Gently slide the drum unit into the machine until it stops at the green lock lever.
    Slide Drum
  11. Turn the green lock lever clockwise to the lock position.
    Turn Lock Lever
  12. Using the green handle, push the drum unit back into the machine until it locks in place.
    Push Drum
  13. Close the machine's front cover.

 

Reset the drum counter

When you replace the drum unit with a new one, you must reset the drum counter by completing the following steps:
 

  1. Close the front cover.
  2. Make sure the machine is turned on.
  3. Press the Up or Down arrow key to display Machine Info., and then press OK.
  4. Press the Up or Down arrow key to display Parts Life, and then press OK.
  5. Press the Up or Down arrow key to display Drum, and then press OK.
  6. Press and hold OK for about five seconds.
  7. Press the Up arrow key to reset the drum counter.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

HL-L8260CDN

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.