RJ-3230B

FAQs & Troubleshooting

FAQs & Troubleshooting

How to change the Media Roll Holder

Make sure you use a Media Roll Holder that supports the core size of your label or paper.

 

  1. Push the Roll Cover Release Lever to open the Roll Compartment Cover.

  2. Hold the left Roll Guide so that it does not rotate, and then remove the currently installed Media Roll Holder using a flathead screwdriver.
    Image

  3. Hold the right Roll Guide so that it does not rotate, and then remove the currently installed Media Roll Holder using a flathead screwdriver.

  4. Attach the Media Roll Holders that match your media's core size to the Roll Guides using a flathead screwdriver. Make sure you use the same size Media Roll Holders.
    Image

  5. Insert the roll.

  6. Close the Roll Compartment Cover until it locks into place.

  7. If the LCD automatically shows [Select Media] or [Auto Detect], select the option you want.
  • You can check each core size at the center of the Media Roll Holders.
  • After closing the roll cover during power-on, the LCD automatically shows [Select Media] or [Auto Detect] setting.
  • If the media is misaligned (protruding) with the Media Roll Holder, fix the media before using it.

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

RJ-3230B, RJ-3250WB

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.