TD-4410D

FAQs & Troubleshooting

FAQs & Troubleshooting

How to set the Head Unit

Movie: How to set the Head Unit

*The video clip is being streamed from YouTube.

 

Place the product on an Electrostatic Discharge (ESD) grounding mat or use anti-static gloves, otherwise this product or its accessories may get damaged or destroyed.

 

  1. Make sure you disconnect the printer from the AC power outlet.
     
  2. Pull up the release levers on both sides of the printer to unlock the Roll Compartment Cover, and then open the cover.

    Do not directly touch the Tear Bar with your hands (except for TD-4420DN(FC)/4550DNWB(FC)). Doing so may result in injury.

  3. Push up the lever on the inside of the cover.

  4. While holding the cable, remove the connector from the head unit.

  5. Connect the connector to the new head unit.

  6. Affix the head unit to the hubs on both sides.

  7. Holding the cover, lift up the head unit by pressing on its central part until it makes a clicking sound.

  8. Close the Roll Compartment Cover until it locks into place.

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

TD-4410D, TD-4420DN, TD-4550DNWB

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.