DCP-J925DW

Vanliga frågor & felsökning

Glossy Paper does not feed correctly.

This issue is common when using paper that exceeds the recommended thickness for the machine.

To correct the feeding issue, add more paper to the paper tray. If the paper feed does not improve, check the following steps.

Step 1. Check your paper

Refer to "User's Guide" in the Manuals section for information on acceptable glossy paper for your Brother machine.
To get the best print quality, we suggest using Brother Premium Glossy Paper.

Step 2. Verify the paper is loaded correctly

Load glossy paper with the shiny side facing down. The coated side of glossy paper is shiny. Avoid touching the shiny (coated) side.
If you are using Brother Premium Glossy Paper, load the Brother glossy paper with the instruction sheet (support sheet provided in the paper packaging) at the bottom of the stack. This helps with this issue.
Gently put the paper into the paper tray print side down and top edge in first. Check that the paper is flat in the tray.
Be careful that you do not push the paper in too far, it may lift at the back of the tray and cause feed issues.

Step 3. Clean the Paper Pick-up Roller

NOTE: Illustrations shown below are from a representative product and may differ from your Brother machine.

Unplug the machine from the AC power outlet (electrical socket).
Pull the paper tray completely out of the machine.

If the machine starts multiple-feeding the last few sheets of paper in the tray, clean the Base Pad (1) with a soft lint-free cloth moistened with water.
After cleaning, wipe the pad with a dry, soft lint-free cloth to remove all moisture.
Open the Jam Clear Cover (1) at the back of the machine.
Clean the Paper Pick-up Rollers (1) with a soft lint-free cloth moistened with water.
Slowly turn the rollers so that the whole surface is cleaned.
After cleaning, wipe the rollers with a dry, soft lint-free cloth to remove all moisture.
Close the Jam Clear Cover. Make sure the cover is closed completely.
Put the paper tray firmly back in the machine.
Re-connect the power cord.