Vanliga frågor & felsökning

Vanliga frågor & felsökning

Printouts have wrinkles.


Please check the following points:

Step 1:

  1. Check that you use the paper that meets our specification.
    Please refer to "What is the recommended paper?".

  2. Check that the drum units and toner cartridges are installed properly.
    Please refer to the instructions, "How do I replace a drum unit?" and "How do I replace the toner cartridge?".

If you still have a print quality problem, please go to the Step 2.

Step 2:

  1. Make sure that the fuser cover (1) inside the back cover is closed properly.Fuser cover
  2. Make sure that the back cover is closed properly.
    Back cover

    When using a straight paper path from the manual feed slot through to the back of the machine to print on thick paper, labels, envelopes or paper that is smaller than 4.1×5.8in. (105×148mm), keep the back cover open.

  3. Make sure that two gray levers inside the back cover, one on the left-hand side and one on the right-hand side, are pulled down.

    The two gray levers are pulled down.

  4. Make sure that the media type settings in the printer driver and in the machine's Paper Type menu matches the type of paper you are using.

Om du inte fick svar på din fråga, har du tittat på andra Vanliga frågor?

Har du tittat efter i manualerna?

Om du behöver mer hjälp kontaktar du Brothers kundtjänst:

Feedback om innehållet

Hjälp oss att göra vår support bättre genom att lämna din feedback nedan.

Steg 1: Hur hjälper informationen på den här sidan dig?

Steg 2: Vill du lägga till ytterligare kommentarer?

Observera att detta formulär endast används för feedback.