Innov-is A150

FAQs & Troubleshooting

FAQs & Troubleshooting

"Change the speed controller mode to "OFF"." message appears on the LCD.

 

Cause

This message is displayed when the sewing speed controller is set to control the zigzag stitch width, and the Start/Stop button is pressed.

 

 

Solution

Use the foot controller to operate the machine.

 

If you want to operate the machine with Start/Stop button, set Width control settings to OFF in the settings screen as follows.

 

  1. Press img01 (Settings key) to display the settings screen.
    img02
     
  2. Display the second page of the settings screen by pressing img03.
    The item img04 (Width control) is selected.
     
  3. Change the value of width control from [ON] to [OFF] by pressing img05 or img06.

    img07
    (1) img08 : Press this key to move to previous page.
    (2) img09 : Press this key to move to next page.
    (3) img10 : Press this key to select the next item.
    (4) img11 : Press this key to select the previous item.
    (5) img12 : Press this key to change the value of the selected item.
    (6) img13 : Press this key to change the value of the selected item.


     
  4. Press img14 (Back key) or img15 (OK key) to close the settings screen.

 

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

Innov-is A150

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.