PT-7600

FAQs & Troubleshooting

FAQs & Troubleshooting
  • Date: 21/04/2008
  • ID: faqp00000081_002

I connected the P-touch to the computer using the enclosed USB cable as instructed by the driver setup dialog box, but the installation does not continue.

Did you press the Power key while holding down the Code key?
If you press only the Power key, the computer does not recognize that the PT-7600 was connected.


Refer to the following procedure:

  1. After the following dialog box appears, connect the P-touch to the computer. Do not turn on the PT-7600 yet.

    Image

    Image

  2. While holding down the Code key Image, press the Power key Image. The P-touch will be detected. Follow the instructions of the dialog box to continue.

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

PT-7600

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit