MFC-9320CW

FAQs & Troubleshooting

FAQs & Troubleshooting

Jam Inside

To clear paper jams, please follow the steps below.


Please confirm that you have installed all toner cartridges and drum units in the machine. Failure to install these items or improper installation may cause a paper jam in the machine. 

 

If the error message remains, open and close the top cover and fuser cover firmly to reset the machine.

 

  1. Turn off the machine's power switch. Unplug the telephone line cord first (if applicable), disconnect all cables and then unplug the power cord from the AC power outlet (electrical socket). Leave the machine turned off for 10 minutes to cool down.
     
  2. Fully open the top cover by lifting up on the handle (1).
    open cover


    HOT SURFACE
    After you have just used the machine , some internal parts of the machine will be extremely hot. Wait at least 10 minutes for the machine to cool down before continuing to the next step.

     

    When the scanner is open, you cannot open the top cover.

     

  3. Take out the drum unit and toner cartridge assemblies. Repeat this for all the drum unit and toner cartridge assemblies.





    • We recommend that you place the drum unit and toner cartridge assemblies on a clean, flat surface with a sheet of disposable paper or cloth underneath it in case you accidentally spill or scatter toner.
    • Handle the toner cartridge carefully. If toner scatters on your hands or clothes, wipe or wash it off with cold water at once.
    • To prevent damage to the machine from static electricity, DO NOT touch the electrodes shown in the illustration
    do not touch_1


    To avoid print quality problems, DO NOT touch the shaded parts shown in the illustrations.

    do not touch_2



  4. Pull out the jammed paper slowly.

    pull the jammed paper

  5. Slide each drum unit and toner cartridge assembly into the machine. Make sure that you match the toner cartridge color to the same color label on the machine. Repeat this for all the drum unit and toner cartridge assemblies.

    slide the drum unit into the machine
     
    C=Cyan, M=Magenta, Y=Yellow, K=Black


  6. Close the top cover of the machine.

    close the cover


  7. Plug the machine's power cord back into the AC power outlet (electrical socket) first, and reconnect all cables and the telephone line cord (if applicable). Turn on the machine's power switch.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

MFC-9120CN, MFC-9320CW

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.