Model discontinued. This page is no longer updated.

MFC-3420C

FAQs & Troubleshooting

FAQs & Troubleshooting

I replaced my ink cartridge, but the LCD is still displaying "Ink Empty".

This is typically caused by an incorrect selection made during the LCD prompting after a cartridge is replaced.

 

When an ink cartridge(s) is replaced, the LCD will ask, "Have you removed Blck? 1 Yes  2 No". This question will be asked for ALL 4 colors in sequence, regardless if the color was replaced. If "1 Yes" is NOT selected for the color(s) that was replaced, the LCD will return to "Ink Empty".

 

Do the following to clear the message:

 

  1. Open the Scanner cover by pulling up on the edge of the scanner just above the LCD.
     
     
  2. After 15 seconds, re-close the Scanner cover.
     
  3. The LCD will then display Have you removed Blck? 1 Yes 2 No. The LCD will display this question for ALL 4 colors (not just the ones replaced). BE SURE to select 1 YES for each ink cartridge that was replaced. If 1 Yes is selected, the LCD will then display Change to new (color)? 1 Yes 2 No. Again, BE SURE to select 1 YES.

    "Change to new (color)?" will only appear if 1 Yes is selected for "Have you removed (color)?" If 2 NO is selected for the "removed" question, the LCD will then move on to the question for the next color.

  4. After all the correct selections are made, the machine will then go into a cleaning.
    Once the cleaning is complete, the LCD will return to date and time.
     

If you still have the same problem, contact Brother Customer Service or the Brother authorized dealer near you.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

MFC-3420C, MFC-3820CN

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.