Innov-is VE2300

FAQs & Troubleshooting

FAQs & Troubleshooting


  • Problem that occurs most in embroidery is misalignment of pattern.
    This is caused mostly because a fabric is loose when it's set into an embroidery frame.
    Make sure to set a fabric tightly into an embroidery frame so that you may hear a drum-like sound if you tap the set fabric lightly.

  • Use a stabilizer material when you sew thin fabrics, stretch fabrics or fabrics which easily pucker.
    Prepare a stabilizer material that is larger than an embroidery frame to be used.
    Make sure to attach right surface of stabilizer material to a fabric securely by using an iron.
    Fabric 1 Fusible side of stabilizer

    2 Fabric(wrong side)
  • Use Brother embroidery threads and needle 75/11 for embroidery.


If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

Innov-is 1000, Innov-is 1200, Innov-is 1250D, Innov-is 4000D/4000, Innov-is 500D, Innov-is 6750D, Innov-is 900, Innov-is 950, Innov-is I / Innov-is 6000D, Innov-is Ie, Innov-is M370, Innov-is NQ3500D, Innov-is NQ3700D, Innov-is NV180, Innov-is NV2600, Innov-is NV2700, Innov-is NV880E, Innov-is VE2200, Innov-is VE2300, Innov-is VM5100, Innov-is VM5200, Innov-is VM6200D, Innov-is XE1, Innov-is XE2, Innov-is XJ1, Innov-is XP1, Innov-is XP2, Innov-is XP3, Innov-is XV, PE-770, PE-DESIGN 10, PE-DESIGN 11, PE-DESIGN 8, PE-DESIGN Lite, PE-DESIGN NEXT, PE-DESIGN PLUS, PE-DESIGN PLUS2, PE-DESIGN Ver.5, PE-DESIGN Ver.6, PE-DESIGN Ver.7, SuperGalaxie 3000/3000C/3000D/3100D

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.