Care and Maintenance (Cleaning the Scanner Glass)

Cleaning the Scanner Glass


If there are unwanted vertical lines in the scanned image or if scanning cannot be done cleanly, the scanning area of the scanner may have become dirty. Clean the scanner glass at the bottom of the machine.
 

  1. Turn off the machine and disconnect the power cord plug, and then disconnect the AC adapter plug from the DC power jack on the back of the machine.

    img
  2. Store away the operation panel.

    First raise the panel until it is vertical, and then lower and store it away.


     

    img

     

  3. While pushing in the tab at the bottom of the machine, pull up on the cover.

     

    image

     

  4. Dampen a soft lint-free cloth with water and firmly wring it out, and then wipe the scanner glass at the inside on the bottom of the machine.
    image

     

  5. Fit the tab on the cover into the notch of the installation slot, and then attach the cover to the machine.
    image (1) Notch

     

  6. After cleaning, perform a test scan.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

CM350, CM900

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.