Innov-is XP1
![FAQs & Troubleshooting FAQs & Troubleshooting](/g/b/shared/img/module/icon_question_33.png) |
FAQs & Troubleshooting |
The amount of thread wound onto the bobbin with the bobbin winder is small.
Possible cause
The bobbin winding slider is set to the less side of the amount of thread wound onto a bobbin.
Remedy
Use the bobbin winding slider to adjust the amount of thread wound onto the bobbin to the level you desire.
![bobbin winding slider bobbin winding slider](/g/b/img/faqend/faqh00101107_000/nz/en/2076074/faqh1107_fig0001.gif) |
(1) Bobbin winding slider
(2) More
(3) Less |
If your question was not answered, have you checked other FAQs?
Have you checked the manuals?
If you need further assistance, please contact Brother customer service:
Related Models
Innov-is XP1, Innov-is XP2, Innov-is XP3
Content Feedback
To help us improve our support, please provide your feedback below.