SDX1200

FAQs & Troubleshooting

What should I do if I want to change the initial setting (position adjustment) for region embossing?

If the initial setting (position adjustment) failed, any of the following may be the cause.

Symptom 1

The adjustment sheet for region embossing or template sheet is not cut cleanly.
Adjust the region embossing position according to the following procedure.

Adjusting the Embossing Template Position

Before adjusting the position, prepare the following.

Paper	A4- or Letter-size thick paper that has not been embossed
Mat	Low Tack Adhesive Mat
Blade	Auto Blade (Black)

The paper used for adjustments can be any color; however, we recommend using thick paper that is colored on the front and white on the back. Attach the paper to the mat with the colored side on the front. After cutting, fold the paper with the colored side on the inside, as shown below.
The paper should have the same thickness as the adjustment sheet included with the Embossing Starter Kit, equivalent to "150 g/m2 - 200 g/m2".

Touch in the home screen.　
Touch or until Premium Functions is displayed, and then touch Premium Functions.
Touch Emboss Setting.
Touch or until Emboss Template Position Adjustment is displayed, and then touch Emboss Template Position Adjustment.
Install the auto blade holder into the carriage of the machine.
Load the mat into the machine.
Press Start key to start cutting.
Press OK key when the cutting is finished.
Press to upload the mat, and then peel off the material from the mat.
Fold the cut Adjustment Sheet in half along the dotted line with printed side up.
Overlap .
Referring to the numbers below the rectangles, press or to enter the number for the cutout that is perfectly aligned on the left and right.
Press the OK key.
Press the OK key.

>> The region emboss initial setting is finished.
Continue to perform region embossing referring to the Instruction Manual for Embossing Starter Kit.