PS-53/55/57

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I wind the bobbin?

  • If the thread spool and/or spool cap are set incorrectly, the thread may tangle on the spool pin.
  • Use the spool cap (large, medium, or small) that is closest in size to the thread spool.
    If a spool cap smaller than the thread spool is used, the thread may become caught in the slit on the end of the spool.

 

  1. Place the spool of thread on the horizontal spool pin and firmly hold it with a spool cap so that the spool of thread will not turn.
    Pass the thread through the thread guide as shown following the dotted line on the top of the machine.

    Use only bobbins recommended by the manufacturer of this machine.
    Using other bobbins may result in damage or injury.

     

  2. Pass the end of the thread through the hole on the bobbin from the inside.
    Place the bobbin onto the bobbin winder shaft and slide the bobbin winder shaft to the right.
    Turn the bobbin clockwise, by hand, until the spring on the shaft slides into the groove of the bobbin.
    image

    (1) Spring on the shaft
    (2) Groove of the bobbin
    (3) Bobbin winder seat
    (4) Bobbin winder shaft

     

  3. While holding the end of the thread, gently depress the foot controller to wind the thread around the bobbin a few times.
    Then stop the machine.
    Trim the excess thread above the bobbin.
     

     

  4. Press down on the foot controller to start.
     

     

  5. After the machine stops automatically when the bobbin is full, take your foot off of the foot controller.

    When removing the bobbin, do not pull on the bobbin winder seat.
    Doing so could loosen or remove the bobbin winder seat, resulting in damage to the machine.

     

  6. Cut the thread, slide the bobbin winder shaft to the left and remove the bobbin.

    The needle bar does not move when the bobbin winding shaft is slid to the right.
    Immediately after winding the bobbin, it is normal to hear the sound of the clutch engaging when beginning to sew or manually turning the handwheel.

    Be sure to follow the process described.
    If the thread is not cut completely, and the bobbin is wound, when the thread runs low it may tangle around the bobbin and cause the needle to break.

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

PS-53/55/57

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.