Model discontinued. This page is no longer updated.

DCP-7010

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I load legal size paper in the paper tray?

To load legal size paper in the paper tray follow the steps listed below:

  1. Pull the paper tray completely out of the machine.
  2. Remove any paper inside the tray.
  3. Adjust the paper width guides to fit the width of the paper.
  4. Centered inside the tray are 2 columns of 1/2-inch horizontal slots. There are gray plastic latches on each side of the area where the slots are located. One of the left side and the other on the right side. To extend the tray for legal size paper, squeeze the latches with one hand and with the other hand pull out the back of the paper tray.
  5. Fan the stack of legal size paper well to avoid paper jams or misfeeds.
  6. Place the paper in the paper tray. The side to be printed on must be face down.
  7. Check that the paper is flat in the tray and below the maximum paper mark. The maximum paper mark is below the "V" cutout on the purple paper width guides.
  8. Put the paper tray firmly back in the Brother machine.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

DCP-7010, FAX-2820, MFC-7220, MFC-7420, MFC-7820N

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.