MFC-9840CDW

FAQs & Troubleshooting

FAQs & Troubleshooting

Printouts have wrinkles.


Please check the following points:

  • Change to the recommended type of paper.
    For more information on the recommended types of paper, please refer to Chapter 2 of the User's Guide for your machine or "What is the recommended paper?".

  • Open the back cover and make sure that the two grey levers, one on the left-hand side and one on the right-hand side, are the same position.

    If you are using the envelope and it creases, pull down the two grey levers to envelope position. When you have finished printing, open the back cover and reset the two grey levers back to the original position.


  • Make sure that the back cover is closed properly.

  • Make sure that paper is loaded properly.

  • Make sure that you choose the proper media type in the printer driver or in the machine's Paper Type menu setting.

  • Turn over the stack of paper in the tray or rotate the paper 180°in the input tray.

  • Make sure that the drum unit is installed properly.
    Please refer to the instructions, "How do I replace the drum unit?".

  • Replace the fuser unit. Contact our Customer Service Center.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

MFC-9840CDW

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.