Innov-is XJ1
 |
FAQ 및 문제 해결 |
Using the embroidery needle plate cover
Under some conditions, based on the type of fabric, stabilizer, or thread being used, there may be some looping in the upper thread. In this case, attach the included embroidery needle plate cover to the needle plate. Attach the cover by inserting the two projections on the underside of the cover into the notches on the needle plate as shown below.
 |
(1) Groove (2) Projection (3) Notch |
To remove the embroidery needle plate cover, place your fingernail in the groove and lift the plate out.
Push the embroidery needle plate cover as far as possible to attach it. If the embroidery needle plate cover is not securely attached, it may cause the needle to break.
내용 피드백
지원을 개선하는 데 도움이 되도록 아래에 피드백을 제공하십시오.
