Innov-is A150

FAQs & Troubleshooting

How do I remove or attach the presser foot ?

Use the appropriate presser foot for the type of stitch that you wish to sew, otherwise the needle may hit the presser foot, causing the needle to bend or break.
Only use presser feet designed specifically for this machine. Use of any other presser foot may result in injuries or damage to the machine.

When a stitch is selected, the symbol for the presser foot that should be used is shown in the LCD. Check that the appropriate presser foot is attached before starting to sew. If the wrong presser foot is attached, attach the appropriate presser foot.
The symbols for certain presser feet, such as zipper foot " I " and the quilting foot, may not appear in the screen.

Press (Needle position button) once or twice to raise the needle.
Lower the presser foot lever.
Press .
>> The screen changes, and all keys and operation buttons are locked (except ).

If is pressed while the presser foot is raised, an error message appears. Lower the presser foot lever and press again.

When replacing the presser foot, be sure to press on the operation panel to lock all keys and buttons, otherwise injuries may occur if the “Start/Stop” button or any other button is pressed and the machine starts.
Raise the presser foot lever.
Press the black button at the back of the presser foot holder in order to remove the presser foot.

(1) Black button
(2) Presser foot holder
Place the appropriate presser foot below the presser foot holder so that the presser foot pin is aligned with the notch in the holder.

(1) Presser foot holder
(2) Notch
(3) Pin
(4) Presser foot type
Slowly lower the presser foot lever so that the presser foot pin snaps into the notch in the presser foot holder.

(1) Presser foot lever
(2) Presser foot holder
(3) Notch
(4) Pin

>> The presser foot is attached.
Raise the presser foot lever to check that the presser foot is securely attached.
Press to unlock all keys and buttons.