The label does not cut well.

If the label does not cut well or tape is jammed in the cutter, tape adhesive may have built up on the cutter blades after repeated use.  To solve this problem, follow the steps below.

 

First, turn the cutter board as shown in the illustration (1).

 

Turn around cutter board

 

 

If you still have difficulties, replace with new cutter unit (Accessory: TC-4) by obtaining from an authorized Brother reseller.
To replace the cutter unit, follow the steps below:

 

  1. Pull out the two sections of the cutter unit (green) in the direction of the arrows shown in the illustration (2).
  2. Install a new cutter unit. Push it in until it snaps into place.

 

Replace cutter unit

 

Do not touch the cutter blade directly with your fingers.

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

PT-E110, PT-H110

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.