DCP-7040

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I clear paper jams at the back of the machine?

To clear paper jams, please follow the steps below.

 


After you have just used the machine, some internal parts of the machine will be extremely hot. When you open the front or back cover (back output tray) of the machine, DO NOT touch the shaded parts shown in the illustration. If you do this, you may get burned.

To prevent damage to the machine caused by static electricity, DO NOT touch the electrodes shown in the illustration.

  1. Open the front cover.
  1. Slowly take out the drum unit and toner cartridge assembly.

We recommend that you place the drum unit and toner cartridge assembly on a clean, flat surface with a sheet of disposable paper or cloth underneath it in case you accidentally spill or scatter toner.

  1. Open the back cover (back output tray).
  1. Pull the tab (1) toward you to open the fuser cover.
  1. Pull the jammed paper out of the fuser unit. If the jammed paper cannot be pulled out easily, push down the tab with one hand as you gently pull out the paper with the other hand.
  1. Close the back cover (back output tray).

  2. Put the drum unit and toner cartridge assembly back in the machine.
  1. Close the front cover.

  • Please confirm that you have installed both a toner cartridge and a drum unit in the machine. If you have not installed a drum unit or have installed the drum unit improperly, then this may cause a paper jam in your Brother machine.
  • If the error message remains, open and close the front cover and fuser cover firmly to reset the machine.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

DCP-7030, DCP-7040, MFC-7320, MFC-7340

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.