DCP-T510W

FAQs & Troubleshooting

FAQs & Troubleshooting

Set Sleep Mode Countdown

The Sleep Mode (or Power Save Mode) setting can reduce power consumption. When the machine is in Sleep Mode, it acts as though it is turned off. The machine will wake up and start printing when it receives a print job or a fax. Use these instructions to set a time delay (countdown) before the machine enters Sleep Mode.
  • The timer will restart if any operation is carried out on the machine, such as receiving a fax or a print job.
  • The factory setting is five minutes.
  • When the machine goes into Sleep Mode, the LCD backlight turns off.

DCP-T310/DCP-T510W/DCP-T710W/MFC-T810W

  1. Press Menu.
  2. Press or to select the following:
    1. Select [General Setup]. Press OK.
    2. Select [Ecology]. Press OK.
    3. Select [Sleep Mode]. Press OK.
    4. Select [1 Min], [2 Mins], [3 Mins], [5 Mins], [10 Mins], [30 Mins], or [60 Mins]. Press OK.
  3. Press Stop/Exit.

MFC-T910DW

  1. Press Settings.
  2. Press or to select the following:
    1. Select [General Setup]. Press OK.
    2. Select [Sleep Mode]. Press OK.
    3. Select [1Min], [2Mins], [3Mins], [5Mins], [10Mins], [30Mins], or [60Mins]. Press OK.
  3. Press Stop/Exit.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

DCP-T310, DCP-T510W, DCP-T710W, MFC-T810W, MFC-T910DW

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.