TD-4750TNWBR
|
GYIK és hibaelhárítás |
RFID calibration does not finish or fails. I cannot write RFID tags.
To solve this issue, try one of the following suggestions:
-
Make sure smart labels with RFID tags are located in the correct position.
-
The RFID tag could be defective. Try another tag.
Always test RFID media on your printer before purchasing large quantities of media.
-
Set the label size correctly. Then calibrate the RFID tag.
-
Set the sensor sensitivity correctly (Sensor > Gap/Bline Ref Rate).
-
Check the data length size of the RFID commands.
Ha kérdésére nem talált választ, megtekintette a további GYIK-eket is?
Megnézte a kézikönyvekben?
Ha további segítségre van szüksége, kérjük, vegye fel a kapcsolatot a Brother ügyfélszolgálatával:
Tartalommal kapcsolatos visszajelzés
Kérjük, segítse munkánkat azzal, hogy visszajelzést küld.