Clean the laser scanner windows.

Follow the steps below to clean the inside of the machine:
 

  1. Press and hold down Power to turn the machine off.
  2. Press the front cover release button and pull open the front cover.

      Open_front_cover
  3. Hold the blue handle of the drum unit. Pull the drum unit out until it stops.

      Pull_drum
  4. Turn the blue lock lever (1) at the left of the machine counterclockwise to the release position. Holding the blue handles of the drum unit, lift the front of the drum unit and remove it from the machine.

      Lock_lever_counterclockwise
  5. Wipe the four scanner windows (1) with a dry, soft, lint-free cloth.

      Wipe_scanner
  6. Make sure the blue lock lever (1) is in the release position as shown in the illustration.
    Lock_lever_release_position
  7. Gently slide the drum unit into the machine until it stops at the blue lock lever.

      Slide_drum
  8. Turn the blue lock lever (1) clockwise to the lock position.

      Lock_lever_clockwise
  9. Push the drum unit in until it stops.

      Push_drum
  10. Close the front cover of the machine.
  11. Turn on the power switch.

Ha kérdésére nem talált választ, megtekintette a további GYIK-eket is?

Megnézte a kézikönyvekben?

Ha további segítségre van szüksége, kérjük, vegye fel a kapcsolatot a Brother ügyfélszolgálatával:

Tartalommal kapcsolatos visszajelzés

Kérjük, segítse munkánkat azzal, hogy visszajelzést küld.

1. lépés: Mennyire volt segítségére az ezen weboldalon kapott információ?

2. lépés: Szeretne még bármilyen megjegyzést hozzáfűzni?

Kérjük, vegye fegyelembe, hogy ezen az űrlapon csak visszajelzéseket várunk.