DCP-T426W

FAQs & Troubleshooting

FAQs & Troubleshooting

Configure Network Settings Using the Control Panel

To configure the machine for your network, use the control panel buttons.

Network Settings

Function Button 1 Button 2 Instructions

Enable the One Push Method of Wi-Fi Protected Setup (WPS).

WiFi Button/LED - Press the button three times.

Enable the PIN Method of Wi-Fi Protected Setup (WPS).

WiFi Button/LED - Press the button five times.
Enter Wi-Fi Mode. WiFi Button/LED image Press the buttons simultaneously.

Set Wireless Direct to On.

Print the Wireless Direct Information Sheet.

WiFi Button/LED Copy Shortcut Press the buttons simultaneously.
Print the Network Configuration Report Sheet. WiFi Button/LED Mono Start Press the buttons simultaneously.

Restart Wi-Fi and Wireless Direct. Use this function to solve wireless network problems.

WiFi Button/LED Colour Start Press the buttons simultaneously.

Wi-Fi Mode

Function Button Instructions
Print the WLAN Report. WiFi Button/LED Press the button once.

Enable or disable Wireless Direct.

Copy Shortcut Press the button once.

Enable or disable Wi-Fi.

Mono Start Press the button once.
Reset the Network settings. Colour Start Press and hold the button for two seconds.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

DCP-T420W, DCP-T426W

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.