What kind of labels can be printed by the Cable Label Tool?
The Cable Label Tool allows you to create labels for cables, patch panels, and other equipment when performing electrical work. To use the Cable Label Tool, click here.
You can create labels as below.
Faceplate
Labels of this type can be used to identify various faceplates. Blocks of text are evenly spaced on a single label.
Cable Wrap
Labels of this type can be wrapped around a cable or wire. The text is rotated 90° counterclockwise and printed.
Cable Flag
Labels of this type can be wrapped around a cable or wire, and both ends of the label stick together to form a flag. The text on flag labels is printed on both ends of the label, leaving a blank space in the middle that wraps around the cable.
1 Flag length at least 5 mm
Patch Panel
Labels of this type can be used to identify various types of panels.
Punch-Down Block
Labels of this type can be used to identify a type of electrical connection often used in telephony. You can enter up to three lines for each block on a single label.
Die-cut Flag
Labels of this type can be printed on special die-cut flag labels to create flag labels for cables and wires.
PVC tube (For E800T / E800TK / E850TKW only)
Tubes of this type can be used to identify or insulate cables, or to protect them from heat.
Heat Shrink Tube
Tubes of this type can be heated to shrink them to fit cables. Use HSe tube cassettes for this type of application.
If your question was not answered, have you checked other FAQs?
