HL-4150CDN

FAQs & Troubleshooting

FAQs & Troubleshooting

Replace Belt

DO NOT use cleaning materials that contain ammonia, alcohol, any type of spray, or any type of flammable substance to clean the outside or inside of the machine. Doing this may cause a fire or electrical shock.

image


To prevent damage to the machine from static electricity, DO NOT touch the electrodes shown in the illustration.

image




To avoid print quality problems, DO NOT touch the shaded parts shown in the illustrations.

image





Replace the belt unit following the steps below:

  1. Make sure that the machine is turned on. Press the front cover release button and then open the front cover.

    image



    image


  2. Hold the green handle of the drum unit. Pull the drum unit out until it stops.

    image



    image




  3. Turn the green lock lever (1) at the left of the machine anti-clockwise to the release position. Holding the green handles of the drum unit, lift the front of the drum unit and remove it from the machine.


    image



    image



  4. Hold the green handle of the belt unit with both hands and lift the belt unit up, then pull it out.


    image



    image



  5. Unpack the new belt unit and put the new belt unit in the machine. Make sure the belt unit is level and fits firmly into place.


    image



    image



  6. Make sure the green lock lever (1) is in the release position as shown in the illustration.


    image



  7. Match the guide ends (2) of the drum unit to the c marks (1) on both sides of the machine, then gently slide the drum unit into the machine until it stops at the green lock lever.


    image



  8. Turn the green lock lever (1) clockwise to the lock position.


    image



  9. Push the drum unit in until it stops.


    image



    image



  10. Close the front cover of the machine.


    When you replace the belt unit with a new one, you need to reset the belt unit counter by completing the following steps:


    1. Press + or - to choose Machine Info Press OK.
    2. Press + or - to choose Reset Parts Life. Press OK.
    3. Press + or - to choose Belt Unit. Press OK.
    4. Press + to reset the belt unit counter.

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

HL-4140CN, HL-4150CDN, HL-4570CDW, HL-4570CDWT

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.