HL-1212W

FAQs & Troubleshooting

FAQs & Troubleshooting

Service Call

The Service Call error appears when there is an error that cannot be cleared by the user. When the Service Call message appears, the following LED indication is shown on the control panel. (All LEDs are blinking.)  

 

ServiceCall

 

Turn off the machine, and then turn it back on and try to print again.
If the error is not cleared after turning the machine off and then back on, press Power. The LEDs will light up as the images below to identify the error.
Make a note of the indication and report the error status to your dealer or Brother Customer Service.

Main PCB failure:

The Ready LED (Error) will blink 7 times or 4 times.

MainPCB4 MainPCB7

Fuser unit failure:

The Ready LED (Ready) will blink 3 times.

FuserUnit

Laser unit failure:

The Ready LED (Ready) will blink 5 times.

LaserUnit

Main motor failure:

The Ready LED (Ready) will blink 6 times.

MainMotor

High voltage failure:

The Ready LED (Ready) will blink twice.

HighVoltage

Zero Cross Error:

The Ready LED (Ready) will blink once.

ZeroCross

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

HL-1110, HL-1112, HL-1210W, HL-1212W

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.