Cause

This message is displayed when a button, such as the "Start/Stop" button, was pressed while the presser foot was raised.

Solution

Lower the presser foot lever before continuing the operation.

Cause

This message is displayed when the buttonhole lever is down, a stitch other than a buttonhole is selected, and a button, such as the "Start/Stop" button, is pressed.

Solution

Lift the buttonhole lever before continuing the operation.

Cause

This message is displayed when the buttonhole lever is up, a buttonhole stitch is selected, and a button, such as the "Start/Stop" button, is pressed.

Solution

Lower the buttonhole lever before continuing the operation.

Cause

This message is displayed when a button, such as the Reverse/reinforcement stitch button, was pressed while the bobbin winder shaft is moved to the right.

Solution

Move the bobbin winder shaft to the left before continuing the operation.

Cause

This message is displayed when the "Start/Stop" button was pressed while the foot controller was connected.

Solution

Disconnect the foot controller, and then press the "Start/Stop" button. Otherwise, operate the machine by using the foot controller.

Cause

The motor locked up because the thread became tangled, or the needle bent and thus hit the needle plate.

Solution

Click the following link to see the details of solutions.

E06 message appears on the LCD.

Cause

This message is displayed when a button, such as the "Start/Stop" button, was pressed after a stitch has been deleted.

Solution

Select a pattern before continuing the operation.

Cause

This message is displayed when the sewing speed controller is set to control the zigzag stitch width, and the "Start/Stop" button is pressed.

Solution

Turn off the width control, or use the foot controller to operate the machine.

Cause

This message is displayed when (Twin needle) is turned on, and a stitch pattern that cannot be sewn with the twin needle is selected.

Solution

Switch to the single needle mode, and replace the twin needle with a single needle before continuing the operation.

Cause

This message is displayed when you try to sew with a stitch other than a straight stitch (middle needle position) while the straight stitch needle plate is installed.

Solution

Turn off the machine, and then replace the needle plate before continuing the operation.

Cause

This message is displayed when the needle plate cover is removed while the machine is still turned on.

Solution

Turn off the machine, and then attach the needle plate cover before continuing the operation.

Cause

If error message "F*" appears in the LCD while the machine is being used, the machine may be malfunctioning. ("*" will be replaced with a number.)

Solution