TD-4750TNWBR
 |
FAQs & Troubleshooting |
RFID calibration does not finish or fails. I cannot write RFID tags.
To solve this issue, try one of the following suggestions:
-
Make sure smart labels with RFID tags are located in the correct position.
-
The RFID tag could be defective. Try another tag.
Always test RFID media on your printer before purchasing large quantities of media.
-
Set the label size correctly. Then calibrate the RFID tag.
-
Set the sensor sensitivity correctly (Sensor > Gap/Bline Ref Rate).
-
Check the data length size of the RFID commands.
If your question was not answered, have you checked other FAQs?
Have you checked the manuals?
If you need further assistance, please contact Brother customer service:
Related Models
TD-4650TNWBR, TD-4750TNWBR
Content Feedback
To help us improve our support, please provide your feedback below.
