TJ-4520TN

FAQs & Troubleshooting

FAQs & Troubleshooting

How to skip the AUTO.BAS program only one time by directly operating the printer

To skip the program at startup, or to calibrate, do the following:

 

  1. Turn off the printer.

  2. Press and hold the right Selection button, and then turn on the Power Switch.

  3. Release the button when READY (Skip AUTO.BAS) appears on the screen.

    You can also release the button when the LED is lit in green.
    The LED colour will change in the following order:
    Amber > red (5 times) > amber (5 times) > green (5 times) > green/amber (5 times) > red/amber (5 times) > green (lit)

  4. The printer will start without running the AUTO.BAS program.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

TJ-4420TN, TJ-4422TN, TJ-4520TN, TJ-4522TN

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.