TJ-4520TN

FAQs & Troubleshooting

FAQs & Troubleshooting

How to set the Gap/Black Mark Sensor as Media Sensor and calibrate the Gap/Black Mark Sensor by directly operating the printer

Follow the instructions below:

 

  1. Turn off the printer.

  2. Press and hold the right Selection button, and then turn on the Power Switch.

  3. For the Black Mark Sensor
    Release the button when Bline Calibration appears on the screen.
    You can also release the button when the LED is flashing in green/amber (5 times).
    The LED colour will change in the following order:
    Amber > red (5 times) > amber (5 times) > green (5 times) > green/amber (5 times) > red/amber (5 times) > green (lit)

    For the Gap Sensor
    Release the button when Gap Calibration appears on the screen.
    You can also release the button when the LED is flashing in red/amber (5 times).
    The LED colour will change in the following order:
    Amber > red (5 times) > amber (5 times) > green (5 times) > green/amber (5 times) > red/amber (5 times) > green (lit)

    You can also calibrate by using the BPM (Brother Printer Management Tool).

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

TJ-4420TN, TJ-4422TN, TJ-4520TN, TJ-4522TN

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.