TD-4650TNWB

FAQs & Troubleshooting

FAQs & Troubleshooting

How to calibrate the Gap/Black Mark Sensor by directly operating the printer

The Gap/Black Mark Sensor sensitivity should be calibrated whenever:

  • A new printer is purchased
  • Label stock is changed
  • Printer initialisation takes place

To calibrate the ribbon and Gap/Black Mark Sensor:

  1. Turn off the printer.
  2. Press and hold the Feed/Pause Button and then turn on the printer.
  3. Release the button when the LED is lit in red/amber (blinks 5 times alternately).
    The LED colour will change in the following order:
    Amber (lit) > Red/Amber (blinks 5 times alternately) (Release the button here) > Amber (5 times) > Green/Red (blinks 5 times alternately) > Green (5 times) > Red (5 times) > Green (lit)

    To select the sensor for calibration, send the correct command to the printer:

    • For the Gap Sensor: the GAP command
    • For the Black Mark Sensor: the BLINE command

    You can also calibrate by using the BPM (Brother Printer Management Tool).

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

TD-4650TNWB, TD-4650TNWBR, TD-4750TNWB, TD-4750TNWBR

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.