Push the cover open lever to open the RD Roll compartment cover. 1 Cover open lever
Open the roll guides by lifting up the roll guide adjustment lever (1) and pulling the roll guide outwards.
Insert an RD Roll into the RD Roll compartment with the roll feeding from the bottom as shown. 1 Roll guide adjustment lever
2 Roll guide
Make sure that the roll guide is properly positioned to prevent the RD Roll from moving sideways.
The thermal sensitive side must be on the outside of the roll and installed as shown to print properly.
While lifting up the roll guide adjustment lever (1), push in both roll guides (2) to the roll width.
Make sure that the RD Roll is positioned straight in the RD Roll compartment.
Close the RD Roll compartment by pressing down on the centre of the cover until it latches.
When using die-cut label (RJ-3150 only), press the Feed button after inserting the RD Roll. The printer will position the label to the correct starting position.
Use genuine Brother media.
Movie: How to set the RD roll.
*The video clip is being streamed from YouTube.
If your question was not answered, have you checked other FAQs?
