How do I install/change the RD roll?

Follow the steps below:

 

  1. Push the cover open lever to open the RD Roll compartment cover.
    Open the cover
    1  Cover open lever

  2. Open the roll guides by lifting up the roll guide adjustment lever (1) and pulling the roll guide outwards.
    Insert an RD Roll into the RD Roll compartment with the roll feeding from the bottom as shown.
    Adjust the roll guide
    1  Roll guide adjustment lever
    2  Roll guide
    • Make sure that the roll guide is properly positioned to prevent the RD Roll from moving sideways.
    • The thermal sensitive side must be on the outside of the roll and installed as shown to print properly.

  3. While lifting up the roll guide adjustment lever (1), push in both roll guides (2) to the roll width.
    Make sure that the RD Roll is positioned straight in the RD Roll compartment.
    Install the roll

  4. Close the RD Roll compartment by pressing down on the centre of the cover until it latches.
    Close the cover
    • When using die-cut label (RJ-3150 only), press the Feed button after inserting the RD Roll. The printer will position the label to the correct starting position.
    • Use genuine Brother media.

     

    Movie: How to set the RD roll.

    *The video clip is being streamed from YouTube.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

RJ-3050, RJ-3150

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.