Press and hold the (Power) button to turn the printer off.
Turn and hold the cover open lever, and open the RD Roll compartment cover.
While pushing the adjuster lock in the direction of the arrow, move it to the left or right. Because the roll guide will also move, adjust the roll guide to match the width of the paper using the scale engraved on the inside of the printer.
1 Adjuster lock
2 Roll guide
3 Scale
Insert an RD Roll into the RD Roll compartment upside down with the labels feeding from the bottom as shown.
- Make sure that the roll guide is properly positioned to prevent the RD Roll from moving sideways.
- If the RD Roll is not inserted correctly, the printer will not print on the correct side of the paper or label.
- When printing on die cut labels, set the roll guide so that there is 0.08 inches (2 mm) of space on both sides (0.16 inches (4 mm) total) of the scale.
Example: When using a 4-inch wide (101.6 mm) label, set the roll guide to a width of 4.16 inches (105.6 mm).
Align the RD Roll with the guide lines.
4 Guide lines
5 Tear bar
Close the RD Roll compartment by pressing on the centre of the cover.
Press and hold the (Power) button to turn the printer on.
When using die cut label, press the (Feed) button after inserting the RD Roll. The printer will position the label to the correct starting position
If your question was not answered, have you checked other FAQs?