Press and hold the ON/OFF button to turn the TD-4000/4100N off. Pull up the left and right levers on the TD-4000/4100N under the RD Roll compartment cover, and open the RD Roll compartment cover.
Squeeze the green lever and adjust the guide to fit the width of the RD roll. Use the scale moulded in the rear compartment to assist with positioning this guide.
Slide the end of the RD roll under the gap (media) sensor.
If the end of the RD roll has not been fed under the gap (media) sensor, the TD-4000/4100N may not be able to detect the media properly.
Insert an RD roll into the roll compartment upside down with the labels feeding from the bottom as shown. Check the position of the roll guide and adjust it to prevent the RD roll from moving sideways.
Incorrect insertion of the RD roll will not print on the correct side of the label.
Position the end of the RD roll to touch the black plastic cutter guard.
Close the RD Roll compartment cover.
Press and hold the ON/OFF button to turn the TD-4000/4100N on.
Die cut label
Press the Feed button. The printer will position the label to the correct starting position. You are now ready to print.
Continuous length label
Press the Feed button twice and the Cut button. The printer will position the label to the correct starting position. You are now ready to print.
If your question was not answered, have you checked other FAQs?
to turn the TD-4000/4100N off. Pull up the left and right levers on the TD-4000/4100N under the RD Roll compartment cover, and open the RD Roll compartment cover.
If the end of the RD roll has not been fed under the gap (media) sensor, the TD-4000/4100N may not be able to detect the media properly.
Incorrect insertion of the RD roll will not print on the correct side of the label.
