QL-700
FAQs & Troubleshooting |
The information on my label is horizontally compressed and not shaped correctly, why?
The dirt on the tape feed roller may cause slipping of the paper. Clean the roller with a cleaning sheet following the steps below.
-
Press and hold the ON/OFF button ( ) to turn the machine off.
-
Hold the machine by the front, and firmly lift the DK Roll compartment cover to open it.
<using image of QL-700>
-
Remove the DK Roll.
-
Remove the backing paper and feed the edge of the cleaning sheet into the printing unit until it reaches the area shown by an arrow in the diagram below.
- Insert the sheet without removing the part of sheet.
- Check that the printing surface of cleaning sheet is upward.
-
Close the DK Roll compartment cover and press the ON/OFF button () to turn the machine on.
-
Press the Feed button for more than one second. The roller spins by 4" (10 cm). The adhesive face of cleaning sheet removes the stain or dust on the roller.
- If you do not press the Feed button for more than one second, the roller spins only 1/3" (8 mm).
- Dispose the cleaning sheet after use.
-
Open the DK cover.
-
Insert the DK roll.
- Make sure that the spool arms are inserted firmly in the spool guides on the left and right.
- Insert the spool with the DK Roll located on the right hand side of the machine.
Content Feedback
To help us improve our support, please provide your feedback below.