Let's take a look at how to wind the bobbin and set the lower thread.

• Only use the plastic bobbin that comes with this machine or bobbins of the same type.

Let's take a look at how to pass the upper thread into the machine and thread the needle.

• Make sure to raise the needle using the needle position button before upper threading.

Let's take a look at how to change the needle.

Let's take a look at how to replacing the presser foot.

• Use the appropriate presser foot for the type of stitch that you wish to sew.
  For details on the presser foot that should be used with the selected stitch, refer to "Stitch Chart" on the operational manual.

Let's try selecting a stitch pattern.

Stitch patterns can be selected through either direct select (by pressing the designated key for a specific stitch) or number selection (by entering the number for the stitch pattern).

Let's start sewing to use the straight stitch.

In the latter part of the movie, it shows you how to sew using the zigzag stitch.

• The operation panel differs depending on models. Refer to the operation to select a pattern for your model.
• The stitch number differs depending on models.

Let's try reverse sewing.

In the latter part of the movie, it shows you how to sew using the automatic reverse/reinforcement stitching function.

Let's take a look at how to adjust the stitch length and width.

Let's check the thread tension.

• Before starting your sewing project, we recommend sewing trial stitches using thread and a piece of fabric that are the same as those used for your project. While checking the sewing results, adjust the thread tension.

Let's take a look at how to clean the race.