XL-6040
FAQs & Troubleshooting |
How do I thread my machine?
-
Raise the presser foot using the Presser Foot Lever.
-
Raise the needle to its highest position by turning the balance wheel toward you (anticlockwise).
-
Place a spool of thread on the horizontal spool pin and press a spool cap onto the spool pin to hold the thread spool firmly in place. The thread end should come from the bottom front of the spool.
-
Deliver the upper thread as shown in this diagram.
-
Make sure to guide the thread through the thread take-up lever from the right to the left.
-
Place thread behind the guide above the needle.
- If the thread take-up lever is lowered, the upper thread can not be wrapped around the thread take-up lever.
- Be sure to raise the Presser Foot Lever and the thread take-up before feeding the upper thread.