RH127

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I draw up the lower thread by hand? (For models equipped with a quick-set bobbin.)

When sewing gathers or darts, you can draw up the lower thread by hand so that some thread will be left over.
Before you draw up the lower thread, put the bobbin back in.

  1. Turn off the machine.

    Turn off the machine


  2. Raise the presser foot lever.

    Raise the presser foot lever.


    (1) Presser foot lever


  3. Remove the bobbin cover.

    Remove the bobbin cover.


    (1) Bobbin cover


  4. Reinstall the bobbin.

    Reinstall the bobbin.


  5. Pass the thread along the slit in the direction of the arrow, and leave it there without cutting it.

    Pass the thread along the slit in the direction of the arrow, and leave it there without cutting it.


  6. While lightly holding the end of the upper thread, slowly turn the handwheel toward you (counterclockwise) by hand to lower and then raise the needle.

    While lightly holding the end of the upper thread, slowly turn the handwheel toward you (counterclockwise) by hand to lower and then raise the needle.


  7. Pull on the upper thread to draw up the lower thread.

    Pull on the upper thread to draw up the lower thread.


    (1) Upper thread
    (2) Lower thread


  8. Pull out about 10 cm (4 inches) of both threads and put them toward the back of the machine under the presser foot.

    Pull out about 10 cm (4 inches) of both threads and put them toward the back of the machine under the presser foot.


    (1) Upper thread
    (2) Lower thread


  9. Replace the bobbin cover.

    Replace the bobbin cover.


    (1) Groove
    (2) Projection

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

AE2700, JK2500NT, LX27NT, LX37NT, RH127, RH137, XQ2700, XQ3700

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.