Innov-is 550SE/ 550

FAQs & Troubleshooting

FAQs & Troubleshooting
  • Date: 06/02/2014
  • ID: faqh00000465_000

How do I manually thread the needle?

When using special thread, thread with a thickness of 130/20 or thicker, the wing needle or the twin needle which cannot be used with the needle threader, thread the needle as described below.

 

 

 

  1. Thread the machine to the needle bar thread guide.

  2. Lower the presser foot lever.

    Lower the presser foot lever 1 Presser foot lever

  3. Pass the thread through the eye of the needle from front to back.

     

  4. Raise the presser foot lever, pass the end of the thread through the presser foot, and then pull out about 5 cm (2 inches) of thread toward the rear of the machine.

Related FAQs

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

BM-3500/2600, BM-3600/2700, Innov-is 10/10A, Innov-is 1200, Innov-is 1250, Innov-is 15, Innov-is 1500D/1500, Innov-is 150SE/ 150, Innov-is 20/20LE, Innov-is 200, Innov-is 2200, Innov-is 27SE, Innov-is 30, Innov-is 35, Innov-is 350SE, Innov-is 400, Innov-is 50, Innov-is 55, Innov-is 550SE/ 550, Innov-is 55FE, Innov-is 600, Innov-is 900, Innov-is 950, Innov-is 955, JK4000, JK7000, NX-200, NX-2000, NX-400Q/400, NX-600, PX-100/200/300, PX-330, QC-1000, XL-2120/2220/2230, XL-2600/2610/2620, XL-3500/ 3510/3520, XL-3600, XL-5010/5020/5030, XL-5011/5012/5021/5031/5032, XL-5050/5060/5070, XL-5500, XL-5600, XL-5700

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit