Innov-is 1250

FAQs & Troubleshooting

FAQs & Troubleshooting

"Lower the presser foot lever." appears on the LCD.

This message appears when the start/stop button, reverse/reinforcement stitch button, thread cutter button or the foot controller is pressed while the presser foot lever is raised.


 

 

  • Proper operation will sound
    One beep
  • Improper(wrong) operation will sound
    Two or four beeps

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

CS-8120, Innov-is 100, Innov-is 1200, Innov-is 1250, Innov-is 1500D/1500, Innov-is 2200, Innov-is 350SE, Innov-is 400, Innov-is 500D, Innov-is 550SE/ 550, Innov-is 600, Innov-is 900, Innov-is 950, Innov-is 955, NX-2000, NX-400Q/400, NX-600, QC-1000, SuperGalaxie 3000/3000C/3000D/3100D

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.