FS130QC

FAQs & Troubleshooting

FAQs & Troubleshooting
  • Date: 31/08/2007
  • ID: faqh00000064_000

An "E4" message appears on the panel.

  • The reverse/reinforcement stitch button or needle position button was pressed while the bobbin winder shaft was moved to the right.
  • Move the bobbin winder shaft to the left before continuing the operation.

 

Each time a key is pressed or an incorrect operation is performed, a beep is sounded.

  • For a correct operation
    One beep is sounded.
  • If an incorrect operation is performed
    Two or four beeps are sounded.
  • If the machine locks up, for example, because the thread is tangled
    The sewing machine continues to beep for four seconds.
    The machine automatically stops.
    Be sure to check for the cause of the error, and correct it before continuing to sew.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

AS-40, BC-2100/2300, BC-2500, CS-8060, DS-120, DS-140, ES-2000, FS100WT, FS130QC, FS140, FS180QC, FS-20, FS200CE, FS210, FS250FE, FS250ME, FS-40, FS-40WT, FS60, FS60s, FS70WT, FS70WTs, Innov-is 150SE/ 150, Innov-is 20/20LE, Innov-is 200, Innov-is 27SE, Innov-is 30, Innov-is 35, JK4000, JK7000, NX-200, XR-6600

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit