MFC-L5700DN

FAQs & Troubleshooting

FAQs & Troubleshooting

My printer takes a long time to start printing when using Airprint. (iOS 16)

Try one of the following methods to enable IPv6:

 

> Using Web Based Management

> Using the Touchscreen (Touchpanel models)

> Using the Touchscreen (1 Line LCD models)

 

 

Using Web Based Management

  1. Print the Network Configuration report.
    > Click here to see how to print the Network Configuration Report.
  2. On a computer that's connected to the same network as your machine, open a web browser.
  3. Type the IP address listed on the Network Configuration report into your browser's address bar, and then press Enter.
    The machine's web interface will open. (For example: http://192.168.1.105)
  4. Click Network > Wired or WirelessIPv6 (Wired) or IPv6 (Wireless).
    step4
  5. Select Enabled, and then click Submit.
    step5

 

Using the Touchscreen (Touchpanel models)

  1. Press the Settings menu.
  2. Press Network.
  3. Select Wired LAN or WLAN.
  4. Select TCP/IP.
  5. Press ▲ or ▼ to select IPv6.
  6. Select On.
  7. Turn the machine off and then on again.

 

Using the Touchscreen (1 Line LCD models)

  1. Press ▲ or ▼ to select Settings.
  2. Press ▲ or ▼ to select Network.
  3. Select Wired LAN or WLAN and press OK.
  4. Press ▲ or ▼ to select TCP/IP and press OK.
  5. Press ▲ or ▼ to select IPv6 and press OK.
  6. Press ▲ or ▼ to select On and press OK.
  7. Turn the machine off and then on again.

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

DCP-L5500DN, DCP-L6600DW, HL-L5100DN(T), HL-L5200DW(T), HL-L6250DN, HL-L6300DW(T), HL-L6400DW(T), HL-L6450DW , MFC-L5700DN, MFC-L5750DW, MFC-L6800DW(T), MFC-L6900DW(T), MFC-L6950DW

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.