HL-4050CDN

FAQs & Troubleshooting

FAQs & Troubleshooting
  • Date: 18/10/2007
  • ID: faq00002474_001

I get white lines or ribbing down the page on duplex print?


Please check the following points:

1: Choose Thin Paper mode in the printer driver and re-send the print job.

If the problem is not resolved after printing a few pages, follow the steps below:

  1. Open the back cover.
  2. Pull down the two grey levers, one on the left-hand side and one on the right-hand side, to position B as shown in the illustration below.

Position B is only for duplex printing with recycled paper when the temperature and humidity are low.

  1. Close the back cover.
  2. Choose Plain Paper mode in the printer driver and re-send the print job.
  3. If the problem is not resolved after printing a few pages, choose Thin Paper mode in the printer driver and re-send the print job.

When you have finished printing, open the back cover and reset the two grey levers back to the original position.

2: Use thicker paper than you are now using.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

HL-4050CDN, HL-4070CDW

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit