DCP-J1140DW

FAQs & Troubleshooting

FAQs & Troubleshooting

Paper is Jammed in the Back of the Machine (Jam Rear)

If the LCD displays [Jam Rear], follow these steps:

  1. Unplug the machine from the electrical socket.
    IMPORTANT
    (MFC-J1010DW)

    Before you unplug the machine from the power source, you can transfer your faxes that are stored in the machine's memory to your computer or another fax machine so you will not lose any important messages.

  2. Pull the paper tray (1) completely out of the machine as shown by the arrow.
    image
  3. Pull the two green levers inside the machine to release the jammed paper.
    image
    image
    Depending on the paper size, it is easier to remove the jammed paper from the front of the machine rather than from the back of the machine.
  4. Squeeze both levers (1), and then open the Jam Clear Cover at the back of the machine.
    image
  5. Slowly pull the jammed paper out of the machine.
    image
  6. Close the Jam Clear Cover. Make sure the cover is closed completely.
    image
  7. Slowly push the paper tray completely into the machine.
    image
  8. Pull out the paper support (1) until it locks into place, and then unfold the paper support flap (2).
    image
  9. Reconnect the power cord.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

DCP-J1050DW, DCP-J1140DW, MFC-J1010DW

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.