DCP-4020C
![]() |
FAQs & Troubleshooting |
How do I replace the Ink Cartridge?
Replace the Ink Cartridge by following the instructions below:
-
Pull the scanner cover release lever and lift the scanner cover.
-
Lift the output paper support and open the ink cartridge cover.
If one or more ink cartridges are empty, for example Black, the LCD shows "INK EMPTY BLACK" and "PLS OPEN COVER"
![](/g/b/img/faqend/faq00000230_005/gb/en/91971/inkreplace-mini.jp.jpg)
-
Remove the ink cartridges that are shown on the LCD.
![](/g/b/img/faqend/faq00000230_005/gb/en/91972/inkreplace-mini2.jpg)
-
Open the new ink cartridge bag for the colour shown on the LCD, and then take out the ink cartridge.
-
Each colour has its own correct position. Insert the new ink cartridge into its carriage by pressing until it clicks.
![](/g/b/img/faqend/faq00000230_005/gb/en/91973/inkreplace-mini3.jpg)
-
After installing the ink cartridges, close the ink cartridge cover, output paper support and scanner cover.
-
If you replaced an ink cartridge while "NEAR EMPTY XXXX" was displayed on the LCD, the LCD will ask you to verify that it was a brand new one.
Example: DID YOU CHANGE BLACK? 1.YES 2.NO.
For each new cartridge you installed, press 1 on the dial pad to automatically reset the ink dot counter for that colour. If the ink cartridge you installed is not a brand new one, please be sure to select 2.
If you wait until the "INK EMPTY XXXX" message is displayed on the LCD, the DCP/MFC will automatically reset the ink dot counter.
Content Feedback
To help us improve our support, please provide your feedback below.