Follow the steps below to replace the drum unit:
 

NOTE: Illustrations shown below are from a representative product and may differ from your Brother machine.

1. Make sure that the machine is turned on.
    
2. Open the top cover until it locks in the open position.
    

   

    

3. Take out the toner cartridge and drum unit assembly for the colour shown on the machine's display.
    

   
    

4. Push down the green lock lever and take the toner cartridge out of the drum unit.

    

    

   

    

5. Unpack the new drum unit, and pull off the protective cover.
    

   

    

6. Put the toner cartridge firmly into the new drum unit until you hear it lock into place. If you install the cartridge correctly, the green lock lever on the drum unit will lift automatically.
    

   

    

7. Clean the corona wire inside the drum unit by gently sliding the green tab from left to right and right to left several times.
    

   

    

   Be sure to return the tab to the home position () (1). The arrow on the tab must be aligned with the arrow on the drum unit. If it is not, printed pages may have a vertical stripe.

    

    

8. Slide the toner cartridge and drum unit assembly into the machine. Make sure you match the toner cartridge colour to the same colour label on the machine.
    

   

    

   

    

9. To keep good print quality, clean the corona wire inside the drum unit of the other colours. (Repeat Step 3, Step 7, and Step 8.)
    
10. Close the top cover of the machine.
     

When you replace a drum unit with a new one, you must reset the drum counter by completing the following steps:

You can see the steps with video clips.   The clip is being streamed from YouTube. (Opens in a new window.) The product shown in this video may differ from the ones that you are using. Video contents may change without prior notice.

1. Press  (Cancel) to interrupt the error.
    
2. Press  (Settings).
    
3. Press All Settings.
    
4. Swipe up or down, or press the Up or Down arrow key to display Machine Info..
    
5. Press Machine Info..
    
6. Press Parts Life.
    
7. Touch the dial pad area to light up the LEDs.
   
    
8. Press and hold # until the machine's display message changes.
    
9. Press the colour of the drum unit you replaced.
    
10. Press Yes.
     
11. Press  (Home).