Follow the procedure below to install additional memory.

1. Turn off the printer power switch, and then unplug the printer. Disconnect the interface cable from the printer.

2. Unscrew the two screws securing the back plate of the main controller board, and then pull out the main controller board.

   

3. Unpack the SO-DIMM and hold it by the edges.

    

   SO-DIMM boards can be damaged by even a small amount of static electricity. Do not touch the memory chips or the board surface. Wear an antistatic wrist strap when you install or remove the board.

    

4. Hold the SO-DIMM with your fingers on the side edges and align the notch in the SO-DIMM with the protrusions in the SO-DIMM slot.

   

5. Put the SO-DIMM diagonally, and then tilt the SO-DIMM toward the main controller board until it clicks into place.

   To remove the SO-DIMM, open the retaining clips on both sides of the SO-DIMM by pushing them outward, grasp both edges of the SO-DIMM and pull it out straight.

    

6. Put the main controller board back into the printer by sliding it into the guide rails.

   

7. Put the metal plate back on and secure the metal plate with the two screws.

8. Reconnect the interface cable (printer cable) to your computer. Plug the printer back in, and then turn on the printer power switch.

9. To check that you have installed the SO-DIMM properly, you can print the Print Settings listing that shows the current memory size. To print the Print Settings listing, while the printer is not in sleep mode, press the Set button in rapid succession 3 times.