HL-7050N

FAQs & Troubleshooting

FAQs & Troubleshooting
  • Date: 16/10/2006
  • ID: faq00000292_014

What kind of memory can I use?


The HL-7050 and HL-7050N printer have 32 MB of standard memory (this may vary by country) and two slots for optional memory expansion (both slots will not be available if the printer is supplied with more than 32Mbytes of memory).

 

You can expand the memory up to 288 MB by installing dual in-line memory modules (DIMMs).

 

The following DIMM size can be installed:

 

<US>

Size
 Manufacture
 No.
16 MB TECHWORKS 12456-0001
32 MB TECHWORKS 12457-0001
64 MB TECHWORKS 12458-0001
128 MB TECHWORKS 12459-0001

 

For more information, visit Techworks web site at http://www.techworks.com/

 

<Europe>

Size
 Manufacture
 No.
16 MB Buffalo Technology 12323-0001
32 MB Buffalo Technology 12324-0001
64 MB Buffalo Technology 12325-0001
128 MB Buffalo Technology 12326-0001

 

 

In general, the DIMM that can be used with the HL-7050 and HL-7050N must have the following specifications:

 

 Type:  100 pin and 32 bit output
 CAS Latency:  2 or 3
 Clock frequency:  66 MHz or more
 Capacity:  16, 32, 64 MB or 128 MB
 Height:  46 mm (1.8 inches) or less
 Parity:  None
 DRAM Type:

 SDRAM 4 Bank
* SDRAM can be used.

Related FAQs

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

HL-7050, HL-7050N

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit